Polymer Roof Factory,   PO Box 200,Vernon VT 05354,802 257 2011,

fax 802 257 0846


Manufacture and sales of ABS roofs for doors, architectural building details and

 windows including bow and bay windows


K Bow roof installation Instructions


Polymer roofs are designed to be installed with auxiliary casing provided by windowmanufacturer or others. See illustration below. This casing is sometimes no more than a piece of 1x1(nominal size) pine that is used to fill in the space between the platform or head board and the outer edge of the window and is used to provide fastening for the roof. Sometimes this piece could be a little wider to better fill in the space between the window and the roof.





1, Install Auxiliary casing: install trim strip

2, Caulk surface of flashing and other surfaces of roof where it meets building and window.

3, These bow window roofs are attached in front by caulking to auxiliary casing.

4, After the roof has been set on the window use galvanized or stainless steel roofing nails to attach the roof flashing to the building. Use the nail holes provided or drill at least 3/16 holes. Do not nail tight: leave room for expansion.

5, Install the siding: do not nail through the flashing flange.

6, No other finishing is recommended and may void warranty.

7, Care must be taken to insure that windows are installed in accordance with manufacturers instructions including support by cables or knee brackets to keep windows from sagging.


15 November 2017                                                           k11